Paver sealcoating is a great way to enhance the life of your asphalt driveway, brick, or paver patio or driveway. A sealant is a way to prevent the surface to absorb moisture. It can also prevent eroding, and make stains make it easier to remove. A sealed driveway can also improve the appearance of your driveway and make it look newer, instead of an older driveway that looks old and drab. Services related to sealing can be offered by paving installation businesses, but all of the materials that you need can be bought at home improvement stores. This makes is completely possible to perform paver sealcoating yourself.
The first step to paver sealcoating is choosing the type of sealer that you will need. This starts with calculating the square footage of the area that you will need to seal. Next, you can go to your local home improvement store and choose a sealer. The employees should be able to steer you to the right sealer just to make sure you have chosen the correct one for your job. It is also important to choose a sealant that is not water-based, but rather solvent-based. Water-based sealant will not be able to stand the wear and tear that a drive-way undergoes.
The next step to beginning your sealcoating job is to clean the surface. The paver driveway needs to be completely clean and dry. It is best to check the weather forecast before starting a project like this, so that you are not interrupted by possible rain. The cleaning should start with a simple sweeping of the driveway, then pressure washing. An extra step could include using a household detergent to clean as well, but, if this is done, pressure washing should be repeated to make sure there is no leftover residue from the detergent.
The third step follows the driveway being left to dry overnight. Then, you can begin sealing. Reading the safety precautions and label on the sealant is vital, to make sure you are aware of any possible hazards. When applying the sealant, you should start in a corner and use a pain roller to apply the sealant over the surface evenly. Sealants can also be applied with a spray device which can be rent. It is acceptable and in fact, recommended to apply a second coat once the first coat is dry. This is done to add to the appearance of the driveway, giving it a wet look.
Finally, the last step is drying and cleanup is the last part of the process. You should at least 3 hours pass before setting foot on the driveway, and at least 24 hours before driving over it. Repeating this process once every two years will provide the best durability for your driveway. This simple do it yourself process can be done in as little as one weekend, and will save you lots of time and money. By doing it yourself, you can surely ensure a job well-done, and paver sealcoating that will last and add protection for your paver driveway.